I have a similar problem. This is gparted 22.0.1 amd64 (though I tried 22.0.2 i586 and amd64 with no success).
I tftpboot my kernel and initrd onto the board across eth0 using PXE/DHCP. The kernel comes up and begins configuring the nics. For some TBD reason in my case, the kernel selects eth1 as its first interface to run ipconfig, it doesn't proceed to eth0 and my filesystem is not available to me.
eth1 isn't connect to a network with a DHCP server and my filesystem.squashfs sits in a local LAN off eth0. I cannot get an option to force the kernel to go to eth0 first, so I am contemplating what options I may have:
Looking for a connected Ethernet interface ... eth0 ? eth1 ?
[ 9.706370] igb 0000:07:00.1 eth1: igb: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX
[ 9.716664] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
Connected eth1 found
Using timeout of 15 seconds for network configuration.
[ 11.187925] igb 0000:07:00.0 eth0: igb: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
[ 11.198659] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
BusyBox v1.22.1 (Debian 1:1.22.0-15) built-in shell (ash)
Enter 'help' for a list of built-in commands.
/bin/sh: can't access tty; job control turned off
(initramfs) IP-Config: eth1 hardware address 00:xx:xx:xx:xx:xx mtu 1500 DHCP RARP
IP-Config: no response after 15 secs - giving up
Creating /etc/resolv.conf
Begin: Trying wget ... some host ip .. -O /live/medium/live/filesystem.squashfs ... Connecting to 10.142.0.1 (10.142.0.1:80)
wget: can't connect to remote host (10.142.0.1): Network is unreachable
Unable to find a live file system on the network
modprobe: module ehci-orion not found in modules.dep
(initramfs) ipconfig eth0
IP-Config: eth0 hardware address 00:xx:xx:xx:xx:xx mtu 1500 DHCP RARP
IP-Config: eth0 complete (dhcp from 10.142.0.101):
address: 10.142.0.129 broadcast: 10.142.255.255 netmask: 255.255.0.0
gateway: 10.142.0.2 dns0 : 172.30.84.40 dns1 : 0.0.0.0
host : host-10-142-0-129
domain : openstacklocal
rootserver: 10.142.0.1 rootpath:
filename : pxelinux.0
(initramfs) ls /run
initramfs net-eth0.conf net-eth1.conf udev
(initramfs) cat /run/net-eth0.conf
DEVICE='eth0'
PROTO='dhcp'
IPV4ADDR='10.142.0.129'
IPV4BROADCAST='10.142.255.255'
IPV4NETMASK='255.255.0.0'
IPV4GATEWAY='10.142.0.2'
IPV4DNS0='172.30.84.40'
IPV4DNS1='0.0.0.0'
HOSTNAME='host-10-142-0-129'
DNSDOMAIN='openstacklocal'
NISDOMAIN=''
ROOTSERVER='10.142.0.1'
ROOTPATH=''
filename='pxelinux.0'
UPTIME='72'
DHCPLEASETIME='86400'
DOMAINSEARCH=''
(initramfs) cat /run/net-eth1.conf
DEVICE='eth1'
PROTO='none'
IPV4ADDR='0.0.0.0'
IPV4BROADCAST='0.255.255.255'
IPV4NETMASK='255.0.0.0'
IPV4GATEWAY='0.0.0.0'
IPV4DNS0='0.0.0.0'
IPV4DNS1='0.0.0.0'
HOSTNAME=''
DNSDOMAIN=''
NISDOMAIN=''
ROOTSERVER='0.0.0.0'
ROOTPATH=''
filename=''
UPTIME='8'
DHCPLEASETIME='0'
DOMAINSEARCH=''
(initramfs) netstat -r
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
default 10.142.0.2 0.0.0.0 UG 0 0 0 eth0
10.142.0.0 * 255.255.0.0 U 0 0 0 eth0
If I could only get the kernel to ipconfig eth0 first -
(initramfs) mkdir live
(initramfs) wget http://10.142.0.1/filesystem.squashfs -O /live/medium/live/file
system.squashfs
Connecting to 10.142.0.1 (10.142.0.1:80)
filesystem.squashfs 100% |*******************************| 189M 0:00:00 ETA
(initramfs) ls
live
(initramfs) cd live
(initramfs) ls
filesystem.squashfs